The EPS extruder is foam recycling machine and it can crush EPS foam waste and melting the waste,then,extrude into melted strand which will be cooled by water and cut into pellets.These pellets can be raw materials for foam making and plastics making.Cause it cheaper price than original raw materials,so,it takes market.
Buyer will operate the EPS extruder after they install them.The machine works by heating to melt EPS foam waste,there are two heating rings at end of each stage.And there is switch on/off to control the heating,so,user can control the temperature by the control box.
To start feeding foam waste,user need to heat the 1st and 2nd stage for 20-40 minutes.User can try to melt a small piece of foam at the machine head to see if the machine reach the set temperature of 200’C.Just start feeding after it reaches the temperature.
User still can feed a sample foam to see the sample can be melted.Big amount of feeding can start after sample go thru.The heating can be off if temperature goes over heating.
The filter screen with 20-80 meshes at 2nd stage can be installed to filter the dust.The bigger meshes,the more dust can be filtered.User need prepare more pieces screen to replace them during working.If the strand not output smoothly,it means that the screen is blocked,so,user need replace a new screen.The used screen can be renewed by burning to be a new screen which can be installed again on EPS extruder .
Youtube for the operation of EPS extruder @ https://youtube.com/shorts/zIF3g942Ses
Myaid Machinery supply EPS recycling equipment from China including EPS compactor,EPS melter,EPS mixer,EPS extruder ,EPE granulator and foam crusher etc.