How to operate NF EPS block machine

Watch Youtube Video to seek for solutions about foam cutting machine and foam recycling machine
nf eps block
nf eps block
0
(0)

The article is for the operators of NF EPS block machine which can make nonflammable EPS insulation sheets.

nf eps block
nf eps block

Preparation and inspection work to be done before the operation of the NF EPS block machine:

  1. Check whether the components and power supply of the NF EPS block machine are normal, and whether there are looseness, leakage and other problems.
  1. Open the tap water valve to check whether the tap water flow is normal and the water flow meets the requirements.
  1. Check whether the switch position of each steam valve of the NF EPS block machine is accurate.
  1. Check the steam pressure reducing valve, plug the safety plug tightly, and then tighten the outer cover.
  1. Drain the water in the device from the drain port.
  1. Check whether each steam pressure control gauge is normal.

 

When the NF EPS block machine shuts down, the work that needs to be done:

  1. Turn off the power supply of the NF EPS block machine, the vacuum pump tap water and the steam valve.
  1. Establish NF EPS block machine operation records and equipment ledger management, and continuously improve the data and operation of NF EPS block machine.
  1. Pay attention to the correct inspection of the NF EPS block machine, the preparations before the operation of the NF EPS block machine, and do the overhaul work according to the equipment service cycle.
  1. Do a good job in the storage and management of vulnerable parts of NF EPS block machine.

How useful was this post?

Click on a star to rate it!

Average rating 0 / 5. Vote count: 0

No votes so far! Be the first to rate this post.

Related Post

Be the first to comment

Leave a Reply

Your email address will not be published.


*